Create an Nx Witness account
Your first step to setting up an Nx Witness enabled camera is to create an Nx Witness account. You can signup for a free account here.
Setup on your device
Depending on the device you want to setup Nx Witness on, you will need to follow different guides. Here are a few guides from Nx Witness to get you started:
Setup on Raspberry Pi
Since using a Raspberry Pi is so common on remote.it, we wanted to provide some even clearer steps on getting setup.
Find your download link
Once you've signed into your Nx Witness account, find the ARM download and copy the download link.
Install Nx Witness
Now that you have your Nx Witness ARM ZIP file link, replace
<URL_TO_NX_WITNESS_ZIP> in the below commands with that link and execute them on the command line of your device:
sudo wget <URL_TO_NX_WITNESS_ZIP>
sudo unzip <NX_WITNESS_ZIP_FILENAME>
sudo chmod +x install.sh
Run Nx Witness
Now that you've installed Nx Witness you can run the media server with the following:
sudo /etc/init.d/networkoptix-mediaserver start
Start on boot
To have Nx Witness start when your device reboots, run the following command:
sudo update-rc.d networkoptix-mediaserver defaults
Configuring your device
Now that you have Nx Witness running on your device, you need make sure your device is configured to connect to the Nx Witness service.
To do so, create a new TCP service using the remote.it connectd installer (by running
sudo connectd_installer on the command line) and set the port to 7001.